Siemens SIMATIC PCS 7 Manual - Halaman 29

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SIMATIC PCS 7. Siemens SIMATIC PCS 7 39 halaman. Process control system, basis library readme v9.0 sp1 online
Juga untuk Siemens SIMATIC PCS 7: Panduan Pengenalan (6 halaman), Manual Sistem (28 halaman), Manual Fungsi (42 halaman), Panduan Petunjuk Pengoperasian (36 halaman), Bacakan Aku (26 halaman)

Halaman Cetak

4 Parameterization

7. In the next step, you will receive a notification that the motor data identification

will be initiated with the next ON command. Confirm with OK.

This step is necessary for good control behavior. The standard behavior for the

motor identification is "Standstill". For this reason, the motor will not start up via

the IOP-2 when it is turned on for the first time via PLC or manually. The drive

will only carry out the command once the switch-on enable signal is removed

and an enable signal is given again.

Figure 4-10

8. The status screen will appear, or the diagnostic screen will appear if there are

active errors or warnings.

You can acknowledge the errors and return to the status screen by pressing

ESC.

Figure 4-11

Integration of a SINAMICS G120X frequency converter in PCS 7

Entry ID: 109793986,

V1.0,

09/2021