Siemens Simatic S7-1500 Panduan Pengguna - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Industri Siemens Simatic S7-1500. Siemens Simatic S7-1500 45 halaman. Digital output module dq 16x230vac/2a st relais (6es7522-5hh00-0ab0)
Juga untuk Siemens Simatic S7-1500: Manual (40 halaman), Manual (37 halaman), Manual (47 halaman), Manual (24 halaman), Manual (34 halaman), Manual (27 halaman), Panduan Konfigurasi (20 halaman), Manual (47 halaman), Manual (43 halaman), Manual (48 halaman), Manual (26 halaman), Manual (28 halaman), Manual (50 halaman), Manual (34 halaman), Panduan Pengguna (44 halaman), Manual (50 halaman), Manual (30 halaman), Manual (41 halaman), Manual (50 halaman), Manual (40 halaman), Manual Pemrograman Keselamatan (48 halaman), Panduan Instruksi Komunikasi (36 halaman), Manual (40 halaman), Manual (25 halaman), Manual (42 halaman), Deskripsi Aplikasi (50 halaman), Manual (28 halaman), Manual (33 halaman), Manual (49 halaman), Manual (36 halaman), Manual (41 halaman), Manual (46 halaman), Manual (38 halaman), Manual (35 halaman), Manual (39 halaman), Manual (28 halaman), Manual (35 halaman), Panduan Peralatan (35 halaman), Manual (50 halaman), Panduan Peralatan (32 halaman), Panduan Peralatan (38 halaman), Manual (29 halaman), Panduan Peralatan (38 halaman), Manual (34 halaman), Manual (36 halaman), Panduan Peralatan (50 halaman), Manual (45 halaman)

Wiring

3.1

This section provides information on the pin assignment of the individual interfaces and the

block diagram of the CPU 1511T-1 PN.

The connector for the power supply is plugged in when the CPU ships from the factory.

The following table shows the pin assignment for a 24 V DC power supply.

①

②

③

④

⑤

Bridged internally:

①

and

②

and

Figure 3-1

If the CPU is supplied by a system power supply, it is not necessary to connect the 24 V

supply.

CPU 1511T-1 PN (6ES7511-1TK01-0AB0)

Manual, 09/2016, A5E36270833-AA

+24 V DC of the supply voltage

Ground of the supply voltage

Ground of the supply voltage for loop-through (maximum of 10 A permitted)

+24 V DC of the supply voltage for loop-through (maximum of 10 A permitted)

Spring opener (one spring opener per terminal)

④

③