Siemens SINAMICS G120 Memulai - Halaman 25

Jelajahi secara online atau unduh pdf Memulai untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 46 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Panduan Petunjuk Pengoperasian (32 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pengoperasian yang Ringkas (32 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

Terminal strips behind the lower front door

Note

Short-circuit at the Control Unit output terminals at full load

If a short circuit occurs at the output terminals when the CU is fully loaded, then the Power

Module switches off the internal power supply for the Control Unit.

3.2.3

Finding a suitable setting for the interfaces

The inputs and outputs of the frequency inverter and the fieldbus interface have specific

functions when set to the factory settings.

When you put the frequency inverter into operation, you can change the function of each of

its inputs and outputs and the setting of the fieldbus interface.

To make the setting process easier, the inverter has various predefined assignments

(macros).

Only the inputs and outputs whose functions change by selecting a specific assignment, are

shown on the following pages.

Converters with CU250S-2 Control Units

Getting Started, 10/2013, FW V4.6, A5E32899990B AA

Installing

3.2 Installing Control Unit