Siemens SINAMICS G120 Panduan Petunjuk Pengoperasian - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 32 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pengoperasian yang Ringkas (32 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

6. When the USB interface is appropriately set, then the "Accessible nodes" screen form

shows the inverters that can be accessed.

Image 4-3

Image 4-4

If you have not correctly set the USB interface, then the following "No additional nodes

found" message is displayed. In this case, follow the description below.

7. Proceed as follows:

You have transferred an inverter accessible via the USB interface into your project.

CU250S-2 Control Units

Compact Operating Instructions, 01/2016, A5E37058195B AA

Inverters found in STARTER

Inverters found in Startdrive

With STARTER

Select the inverter ☑.

•

Press the "Accept" button.

•

4.1 Commissioning with STARTER or Startdrive

With Startdrive

Transfer the inverter into the project using the menu: "Online -

Upload device as new station (hardware and software)".

Commissioning