Siemens SINAMICS G120 Panduan Petunjuk Pengoperasian - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 32 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pengoperasian yang Ringkas (32 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

Installing

3.1

Installing the Control Unit - General

Each Power Module has an appropriate holder for the Control Unit and a release

mechanism.

Inserting the Control Unit

Proceed as follows to plug the Control

Unit onto a Power Module:

1. Place the two catches of the Control

Unit in the matching grooves of the

Power Module.

2. Press the Control Unit onto the

Power Module until you hear that it

latches.

You have now plugged the Control Unit

onto the Power Module.

Removing the Control Unit

Remove the Control Unit from the Power Module by pressing the release mechanism.

Special features for the PM240 FSGX Power Module

To insert or detach the Control Unit, you must release the two screws

at the front cover, slightly shift the front cover upwards and remove

towards the front.

Reattach the front cover before you commission the device.

Permissible Power Modules

You may operate the Control Unit with the following Power Modules:

• PM240

• PM240-2

CU250S-2 Control Units

Compact Operating Instructions, 01/2016, A5E37058195B AA

• PM250

• PM260

• PM340 1AC