Siemens SINAMICS G120 Memulai - Halaman 23

Jelajahi secara online atau unduh pdf Memulai untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 30 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Panduan Petunjuk Pengoperasian (32 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pengoperasian yang Ringkas (32 halaman), Manual (42 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

The basic commissioning wizard ends with the following dialog:

To complete basic commissioning, the motor data identification, selected during basic

commissioning must be performed via switching on the inverter. This can be done via

the chosen command source (e.g. terminals, BOP or communication) or via STARTER

as shown in the dialog box below.

Motor Data identification via STARTER

First click "Control panel" to open the dialog, then press "Assume control priority"

(when connected via PC connection Kit, select BOP link (RS232) (the "assume-button"

changes to "Return") and select "Enables". Now the ON and OFF buttons get active.

Press the ON button start the Motor data identification. While Motor data identification

is active, the

CU240E

Getting Started, 10/2007, A5E01301680B AA

-button is disabled and in the alarm 541 "Motor Identification active"

Commissioning