Siemens SINAMICS G120 Manual - Halaman 11

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Industri Siemens SINAMICS G120. Siemens SINAMICS G120 42 halaman. Using blocksize converters in marine applications
Juga untuk Siemens SINAMICS G120: Memulai (46 halaman), Panduan Petunjuk Pengoperasian (32 halaman), Memulai (30 halaman), Petunjuk Pemasangan Perangkat Keras (2 halaman), Petunjuk Pemasangan dan Panduan Pemilik (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Instalasi (2 halaman), Petunjuk Pengoperasian yang Ringkas (32 halaman), Memulai (50 halaman), Panduan Perangkat (34 halaman), Panduan Pemasangan Cepat (2 halaman), Deskripsi Aplikasi (50 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Manual (31 halaman), Manual Aplikasi (34 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman), Petunjuk Pengoperasian yang Ringkas (2 halaman)

Halaman Cetak

4 SINAMICS G120 Add-On Instructions

Basic Speed Control –Telegram 1

4.3

4.3.1

Functionality

The G120 Simple Speed Block provides an interface for basic speed control of a

SINAMICS drive via EtherNet/IP. The drive is configured for control using Standard

Telegram Type 1 which presets the drive speed reference and control word to be

sourced from the communication interface.

4.3.2

Schematic Ladder Representation

Figure 4-1

4.3.3

Input and Output Parameters

Table 4-4 Input parameters

Variable Name

G120_Speed_Block

ON_OFF1

OFF2

OFF3

RUN_SET_POINT

FAULT_RESET

RPM_SET_SPEED

MAX_SPEED

SINAMICS G: Control of a G120 with an Allen-Bradley controller

(Compact/ ControlLogix with RSLogix 5000) via EtherNet/IP

Entry-ID: 82843076,

V4.0,

G120 Simple Speed Block

Data Type

Instance Data

BOOL

REAL

09/2018

Description

Drive Enable (ON/OFF1)

1 = Enable Drive

2 = Ramp down and disable drive

Coast Stop Command

0 = Off2 (Immediate disable)

1 = No OFF2 command

Fast Stop command

0 = OFF3 Fast ramp and disable drive

1 = No OFF3 command

Speed setpoint enable

0 = Setpoint disabled

1 = Setpoint enabled

Reset active drive faults

0 = No fault reset

1 = Reset fault(s) on rising edge

Speed setpoint in [rpm]

Speed at 100% setpoint

Must be the same p2000 ( of the drive)