Siemens SITRANS WW200 Panduan Petunjuk Pengoperasian - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens SITRANS WW200. Siemens SITRANS WW200 36 halaman. Weighfeeders

Halaman Cetak

Commissioning

7.3 Changing the conveyor belt

Your system has been supplied with soft PVC seal strips. Position the seal strips on the belt as

shown.

①

②

③

Note

Skirtboard seal stripping is not FDA or USDA approved material, and should be removed for

critical food applications.

7.3

Changing the conveyor belt

ALWAYS STOP the belt, lock-out, and/or place a "Do Not Energize" tag on the main

disconnect before working on or around the weighfeeder.

Depending on the size of the weighfeeder, several personnel may be required to remove and

re-install the belt.

1. On enclosed models, open and remove the access and non-access side panels.

2. Mark the current position of the telescoper for reference. This will be a reference when you

re-install the belt. Loosen the telescopers to remove tension from the belt.

3. Remove support posts on the belt change side, and the belt side roller below the belt plow.

Remove tension from the belt scraper, and remove all other components for belt changing.

Note

Skirtboard removal or adjustment is not normally necessary to perform belt removal or

installation, nor is it recommended. However, if the belt has a corrugated sidewall this will be

required.

Pulley

Seal strip

Skirtboard

WARNING

④

Do not force seal strip against belt

⑤

Belt

Operating Instructions, 06/2018, A5E33560654-AC

SITRANS WW200