Siemens SITRANS WW200 사용 설명서 - 페이지 18

{카테고리_이름} Siemens SITRANS WW200에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens SITRANS WW200 36 페이지. Weighfeeders

Commissioning

7.3 Changing the conveyor belt

Your system has been supplied with soft PVC seal strips. Position the seal strips on the belt as

shown.

①

②

③

Note

Skirtboard seal stripping is not FDA or USDA approved material, and should be removed for

critical food applications.

7.3

Changing the conveyor belt

ALWAYS STOP the belt, lock-out, and/or place a "Do Not Energize" tag on the main

disconnect before working on or around the weighfeeder.

Depending on the size of the weighfeeder, several personnel may be required to remove and

re-install the belt.

1. On enclosed models, open and remove the access and non-access side panels.

2. Mark the current position of the telescoper for reference. This will be a reference when you

re-install the belt. Loosen the telescopers to remove tension from the belt.

3. Remove support posts on the belt change side, and the belt side roller below the belt plow.

Remove tension from the belt scraper, and remove all other components for belt changing.

Note

Skirtboard removal or adjustment is not normally necessary to perform belt removal or

installation, nor is it recommended. However, if the belt has a corrugated sidewall this will be

required.

Pulley

Seal strip

Skirtboard

WARNING

④

Do not force seal strip against belt

⑤

Belt

Operating Instructions, 06/2018, A5E33560654-AC

SITRANS WW200