Siemens TPS3G09 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Industri Siemens TPS3G09. Siemens TPS3G09 8 halaman.

WARNING -

Failure to Follow These Instructions Could Result in Death or Serious Injury

•

Only qualiﬁed licensed electricians should install or service SPDs

•

Hazardous voltages exist within SPDs

•

SPDs should never be installed or serviced when energized

•

Use appropriate safety precautions including Personal Protection Equipment

•

Failure to follow these instructions can result in death, serious injury, and/or equipment damage.

•

This manual shall be read in entirety prior to installing

Bonding and Grounding Hazard

Verify that the neutral conductor in the service entrance equipment is bonded to ground in accordance with the National

Electrical Code (NEC®) and all applicable codes.

Verify that the neutral terminal (XO) on the secondary side of distribution transformers are grounded to the system ground

in accordance with the NEC® and all applicable codes.

During installation into an electrical system the SPD must not be energized until the electrical system is completely installed,

inspected and tested. All conductors must be connected and functional including the neutral (if required). The voltage

rating of the SPD and system must be verified before energizing the SPD.

Failure to follow these guidelines can lead to abnormally high voltages at the SPD. This may cause the SPD to fail. The

warranty is voided if the SPD is incorrectly installed and/or if the neutral conductor in the service entrance equipment or

downstream of separately derived systems is not bonded to ground in accordance with the NEC®.

Do Not Hi-Pot Test SPDs

Any factory or on-site testing of power distribution equipment that exceeds normal operating voltage such as

high-potential insulation testing, or any other tests where the suppression components will be subjected to higher voltage

than their rated Maximum Continuous Operating Voltage (MCOV) must be conducted with the SPD disconnected from the

power source. For 4-wire systems, the neutral connection at the SPD must also be disconnected prior to performing high-

potential testing and then reconnected after test completion.

Failure to disconnect SPD and associated components during elevated voltage testing will damage the SPD and will void

the warranty.

Hazardous Voltage & Shock Hazard