Siemens ULTRAMAT 6F Panduan Petunjuk Pengoperasian - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Peralatan Industri Siemens ULTRAMAT 6F. Siemens ULTRAMAT 6F 49 halaman. Gas analyzer for the determination of ir-absorbing gases
Juga untuk Siemens ULTRAMAT 6F: Manual Peralatan Tambahan (20 halaman), Panduan Keselamatan (24 halaman)
Halaman Cetak
Tools
You need the following tools and aids to install the flame arrestors:
● for all devices
–
SW 21 open end wrench
● for CALOMAT 62F
–
PTFE thread seal tape according to DIN EN 751-3 class F or class FRp
Connection for OXYMAT 6F and CALOMAT 6F
To install the flame arrestors, proceed as follows:
1. Remove the protective plug, the union nut and the clamp rings from the sample gas inlet and outlet.
①
Sample gas inlet and outlet
②
Clamp rings
③
Union nut
④
Protective plug
2. Remove the flame arrestor with adapter from the packaging and remove the protective plug.
3. Use a suitable tool (open-end wrench SW 21) to install the flame arrestor with adapter on the sample gas inlet and outlet
in a wrench tight manner.
①
Sample gas inlet and outlet
②
Flame arrestor with adapter
③
Sample gas connection
4. The screwed joints of the flame arrestor with a G1/4" pipe thread according to ISO 228 serve as gas connections.
Choose a material for the gas supply and exhaust lines that is suitable for the sample gas. Observe the information in the
relevant operating instructions during installation.
12
Compact Operating Instructions in accordance with EN 61010-1 and EN 60079-0
A5E45779389002-01, 09/2018