Siemens ULTRAMAT 6F 사용 설명서 - 페이지 12

{카테고리_이름} Siemens ULTRAMAT 6F에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Siemens ULTRAMAT 6F 49 페이지. Gas analyzer for the determination of ir-absorbing gases
Siemens ULTRAMAT 6F에 대해서도 마찬가지입니다: 추가 장비 매뉴얼 (20 페이지), 안전 매뉴얼 (24 페이지)

페이지 인쇄

Tools

You need the following tools and aids to install the flame arrestors:

● for all devices

–

SW 21 open end wrench

● for CALOMAT 62F

–

PTFE thread seal tape according to DIN EN 751-3 class F or class FRp

Connection for OXYMAT 6F and CALOMAT 6F

To install the flame arrestors, proceed as follows:

1. Remove the protective plug, the union nut and the clamp rings from the sample gas inlet and outlet.

①

Sample gas inlet and outlet

②

Clamp rings

③

Union nut

④

Protective plug

2. Remove the flame arrestor with adapter from the packaging and remove the protective plug.

3. Use a suitable tool (open-end wrench SW 21) to install the flame arrestor with adapter on the sample gas inlet and outlet

in a wrench tight manner.

①

Sample gas inlet and outlet

②

Flame arrestor with adapter

③

Sample gas connection

4. The screwed joints of the flame arrestor with a G1/4" pipe thread according to ISO 228 serve as gas connections.

Choose a material for the gas supply and exhaust lines that is suitable for the sample gas. Observe the information in the

relevant operating instructions during installation.

Compact Operating Instructions in accordance with EN 61010-1 and EN 60079-0

A5E45779389002-01, 09/2018