Cisco 6800 Series Instalasi Perangkat Keras - Halaman 12

Jelajahi secara online atau unduh pdf Instalasi Perangkat Keras untuk Telepon IP Cisco 6800 Series. Cisco 6800 Series 20 halaman. Ip phone, multiplatform phones
Juga untuk Cisco 6800 Series: Panduan Memulai Cepat (3 halaman), Panduan Pengguna (8 halaman), Panduan Pemeliharaan (8 halaman), Panduan Pengguna (14 halaman), Panduan Pemecahan Masalah (12 halaman), Panduan Memulai Cepat (4 halaman), Panduan Pengguna (22 halaman), Panduan Memulai Cepat (4 halaman), Panduan Instalasi (39 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman)

Mount the Base Station or Repeater on the Wall

• Base station without PoE: Plug the power adapter into the base station and route the cable through the

• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.

Step 3

Slide the stand into the device and press it until it clicks into place.

This graphic shows the stand connection to the base station. The back of the repeater is similar to the base

station.

Step 4

Base station only: Plug the Ethernet cable into the LAN port.

Step 5

If required, plug the power adapter into the electrical outlet.

What to do next

Do one of these:

• Base station installation:

• Repeater installation:

Mount the Base Station or Repeater on the Wall

You can mount the base station or repeater on a wall. You put two screws into the wall and slip the base

station or repeater onto the screw heads or you can use the ceiling mount bracket.

We recommend that you mount the base station or repeater as high as possible on a wall. If possible, mount

it at a downward facing angle for better radio coverage.

The base station and repeater have a range of up to 984 feet (300 meters) outdoors and a range of 164 feet

(50 meters) indoors.

Hardware Installation

slot in the base station.

• Manual configuration:

• Automatic configuration:

Add a Repeater

Sign into the Administration Web Page

Hardware Installation

and

Configure the Base Station

and

Start Handset Registration