Cisco 6800 Series Installation du matériel - Page 12

Parcourez en ligne ou téléchargez le pdf Installation du matériel pour {nom_de_la_catégorie} Cisco 6800 Series. Cisco 6800 Series 20 pages. Ip phone, multiplatform phones
Également pour Cisco 6800 Series : Manuel de démarrage rapide (3 pages), Manuel de l'utilisateur (8 pages), Manuel d'entretien (8 pages), Manuel de l'utilisateur (14 pages), Manuel de dépannage (12 pages), Manuel de démarrage rapide (4 pages), Manuel de l'utilisateur (22 pages), Manuel de démarrage rapide (4 pages), Manuel d'installation (39 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages)

Cisco 6800 Series Installation du matériel

Mount the Base Station or Repeater on the Wall

• Base station without PoE: Plug the power adapter into the base station and route the cable through the
• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.
Step 3
Slide the stand into the device and press it until it clicks into place.
This graphic shows the stand connection to the base station. The back of the repeater is similar to the base
station.
Step 4
Base station only: Plug the Ethernet cable into the LAN port.
Step 5
If required, plug the power adapter into the electrical outlet.
What to do next
Do one of these:
• Base station installation:
• Repeater installation:
Mount the Base Station or Repeater on the Wall
You can mount the base station or repeater on a wall. You put two screws into the wall and slip the base
station or repeater onto the screw heads or you can use the ceiling mount bracket.
We recommend that you mount the base station or repeater as high as possible on a wall. If possible, mount
it at a downward facing angle for better radio coverage.
The base station and repeater have a range of up to 984 feet (300 meters) outdoors and a range of 164 feet
(50 meters) indoors.
Hardware Installation
12
slot in the base station.
• Manual configuration:
• Automatic configuration:
Add a Repeater
Sign into the Administration Web Page
Sign into the Administration Web Page
Hardware Installation
and
Configure the Base Station
and
Start Handset Registration