Cisco 6800 Series Installation du matériel - Page 13

Parcourez en ligne ou téléchargez le pdf Installation du matériel pour {nom_de_la_catégorie} Cisco 6800 Series. Cisco 6800 Series 20 pages. Ip phone, multiplatform phones
Également pour Cisco 6800 Series : Manuel de démarrage rapide (3 pages), Manuel de l'utilisateur (8 pages), Manuel d'entretien (8 pages), Manuel de l'utilisateur (14 pages), Manuel de dépannage (12 pages), Manuel de démarrage rapide (4 pages), Manuel de l'utilisateur (22 pages), Manuel de démarrage rapide (4 pages), Manuel d'installation (39 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages)

Hardware Installation

In this task, the term device means the base station or repeater.

Before you begin

You need:

• Pencil

• Level

• Tape measure

• Mounting hardware (screws and wall plugs) suitable for the wall construction. You can also use the

ceiling mount bracket.

• Base station: LAN connection close to the mounting location.

• Base station: If you do not use PoE, a power outlet close to the mounting location.

• Repeater: A power outlet close to the mounting location.

• Ensure that the base station can communicate with the network (see

6). After it can communicate and the LED is green, you can unplug the cables.

Determine the best placement, taking into account the coverage area and the building construction materials.

• If you have a 210 Multi-Cell Base Station, you may need to add additional base stations or repeaters.

• If you have a 110 Single-Cell Base Station, you may need to add 110 Repeaters.

You can use the site survey tool on the handset to plan placement.

Procedure

Step 1

Hold the level in the desired location and at least 2.25 inches (5.7 cm) below the ceiling, and draw a level

line.

Step 2

Mark the placement of the screws.

• Without the ceiling mount bracket: Mark the line so that the screws are 2.126 inches (54 mm) apart

(center to center).

Mount the Base Station or Repeater on the Wall

Install the Base Station, on page

Hardware Installation