Cisco 6800 Series Installation du matériel - Page 14

Parcourez en ligne ou téléchargez le pdf Installation du matériel pour {nom_de_la_catégorie} Cisco 6800 Series. Cisco 6800 Series 20 pages. Ip phone, multiplatform phones
Également pour Cisco 6800 Series : Manuel de démarrage rapide (3 pages), Manuel de l'utilisateur (8 pages), Manuel d'entretien (8 pages), Manuel de l'utilisateur (14 pages), Manuel de dépannage (12 pages), Manuel de démarrage rapide (4 pages), Manuel de l'utilisateur (22 pages), Manuel de démarrage rapide (4 pages), Manuel d'installation (39 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (2 pages)

Mount the Base Station or Repeater on the Wall

• With the ceiling mount bracket: Hold the bracket so that two of the holes intersect the line. Mark the

holes.

Step 3

Install the wall plugs as described by the manufacturer.

Step 4

Insert the screws.

• Without the ceiling mount bracket: Screw in the screws until there is about 0.375 inches (9.52 mm)

between the screw head and the wall.

• With the ceiling mount bracket: Hold the bracket over the holes and screw in the screws until the bracket

doesn't move.

Step 5

Base station only: Connect the Ethernet cable to the base station and route the cable through the slot in the

base station.

Step 6

Provide power to the device:

• Base station with PoE on the LAN: Additional power is not required.

• Base station without PoE: Plug the power adapter into the base station and route the cable through the

slot in the base station.

• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.

Step 7

Put the device on the wall.

• Without the ceiling mount bracket: This diagram shows the alignment of the screw heads and the device.

Hardware Installation