Cisco 6800 Series 하드웨어 설치 - 페이지 14

{카테고리_이름} Cisco 6800 Series에 대한 하드웨어 설치을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6800 Series 20 페이지. Ip phone, multiplatform phones
Cisco 6800 Series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (3 페이지), 사용자 설명서 (8 페이지), 유지 관리 매뉴얼 (8 페이지), 사용자 설명서 (14 페이지), 문제 해결 매뉴얼 (12 페이지), 빠른 시작 매뉴얼 (4 페이지), 사용자 설명서 (22 페이지), 빠른 시작 매뉴얼 (4 페이지), 설치 매뉴얼 (39 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지), 빠른 시작 매뉴얼 (2 페이지)

Mount the Base Station or Repeater on the Wall

• With the ceiling mount bracket: Hold the bracket so that two of the holes intersect the line. Mark the

holes.

Step 3

Install the wall plugs as described by the manufacturer.

Step 4

Insert the screws.

• Without the ceiling mount bracket: Screw in the screws until there is about 0.375 inches (9.52 mm)

between the screw head and the wall.

• With the ceiling mount bracket: Hold the bracket over the holes and screw in the screws until the bracket

doesn't move.

Step 5

Base station only: Connect the Ethernet cable to the base station and route the cable through the slot in the

base station.

Step 6

Provide power to the device:

• Base station with PoE on the LAN: Additional power is not required.

• Base station without PoE: Plug the power adapter into the base station and route the cable through the

slot in the base station.

• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.

Step 7

Put the device on the wall.

• Without the ceiling mount bracket: This diagram shows the alignment of the screw heads and the device.

Hardware Installation