Cisco 6800 Series Instalación del hardware - Página 14

Navegue en línea o descargue pdf Instalación del hardware para Teléfono IP Cisco 6800 Series. Cisco 6800 Series 20 páginas. Ip phone, multiplatform phones
También para Cisco 6800 Series: Manual de inicio rápido (3 páginas), Manual del usuario (8 páginas), Manual de mantenimiento (8 páginas), Manual del usuario (14 páginas), Manual de solución de problemas (12 páginas), Manual de inicio rápido (4 páginas), Manual del usuario (22 páginas), Manual de inicio rápido (4 páginas), Manual de instalación (39 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas), Manual de inicio rápido (2 páginas)

Mount the Base Station or Repeater on the Wall

• With the ceiling mount bracket: Hold the bracket so that two of the holes intersect the line. Mark the

holes.

Step 3

Install the wall plugs as described by the manufacturer.

Step 4

Insert the screws.

• Without the ceiling mount bracket: Screw in the screws until there is about 0.375 inches (9.52 mm)

between the screw head and the wall.

• With the ceiling mount bracket: Hold the bracket over the holes and screw in the screws until the bracket

doesn't move.

Step 5

Base station only: Connect the Ethernet cable to the base station and route the cable through the slot in the

base station.

Step 6

Provide power to the device:

• Base station with PoE on the LAN: Additional power is not required.

• Base station without PoE: Plug the power adapter into the base station and route the cable through the

slot in the base station.

• Repeater: Plug the power adapter into the repeater and route the cable through the slot in the repeater.

Step 7

Put the device on the wall.

• Without the ceiling mount bracket: This diagram shows the alignment of the screw heads and the device.

Hardware Installation