Cisco 6945 Series Panduan Pengguna - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco 6945 Series. Cisco 6945 Series 34 halaman. 6900 series
Juga untuk Cisco 6945 Series: Lembar data (5 halaman), Referensi Cepat (2 halaman), Catatan Rilis (18 halaman), Panduan Pengguna (10 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (8 halaman), Panduan Administrasi (14 halaman), Setup Manual (16 halaman), Fitur (29 halaman), Panduan Memulai Cepat (2 halaman), Instalasi Cepat & Panduan Pengguna (12 halaman), Panduan Pengguna Referensi Cepat (2 halaman), Manual (2 halaman), Petunjuk (3 halaman), Panduan Memulai Cepat (2 halaman), Panduan Fitur (4 halaman), Panduan Instalasi Cepat (12 halaman), Panduan Referensi Cepat (2 halaman)

Cisco 6945 Series Panduan Pengguna
Operating Your Phone
If your phone supports auto-pickup, you are connected to the call.
If the call rings, press the Answer soft key to connect to the call.

End a Call

• Hang up the handset.
• If you are using a headset, press the Headset button or the EndCall soft key.
• If you are using a speakerphone, press the Speaker button or the EndCall soft key.

Establish/End a Conference Call

Your system administrator must configure the system for a three-party or eight-party ad-hoc conference.
Procedure
During a call, press the Conference button to open a new line and put the first party on hold.
Step 1
Place a call to another number.
Step 2
Press Conference button again to add the new party to the call.
Step 3
Perform any of the following steps to end a conference call:
Step 4
• Hang up the handset, or press the Cancel soft key.
• Depending on the configuration, when the conference call initiator disconnects, the conference call
• To end the conference and remain connected to the most recent call, press the Conf soft key. The older

Hold/Resume a Call

Procedure
Press the Hold button.
Step 1
Press the Resume soft key or the flashing green line button to resume the call.
Step 2
If your phone supports multiple lines, you can use line buttons to swap between holding and active calls.
Step 3
Example:
OL-24413-01
terminates.
call is placed on hold.
Cisco Unified IP Phone 6945 User Guide for Cisco Unified Communications Manager Express Version 8.8 (SCCP)

End a Call

19