Cisco 6945 Series Посібник користувача - Сторінка 23

Operating Your Phone

If your phone supports auto-pickup, you are connected to the call.

If the call rings, press the Answer soft key to connect to the call.

End a Call

• Hang up the handset.

• If you are using a headset, press the Headset button or the EndCall soft key.

• If you are using a speakerphone, press the Speaker button or the EndCall soft key.

Your system administrator must configure the system for a three-party or eight-party ad-hoc conference.

Procedure

During a call, press the Conference button to open a new line and put the first party on hold.

Step 1

Place a call to another number.

Step 2

Press Conference button again to add the new party to the call.

Step 3

Perform any of the following steps to end a conference call:

Step 4

• Hang up the handset, or press the Cancel soft key.

• Depending on the configuration, when the conference call initiator disconnects, the conference call

• To end the conference and remain connected to the most recent call, press the Conf soft key. The older

Procedure

Press the Hold button.

Step 1

Press the Resume soft key or the flashing green line button to resume the call.

Step 2

If your phone supports multiple lines, you can use line buttons to swap between holding and active calls.

Step 3

Example:

OL-24413-01

terminates.

call is placed on hold.

Cisco Unified IP Phone 6945 User Guide for Cisco Unified Communications Manager Express Version 8.8 (SCCP)