Epson 835p - PowerLite XGA LCD Projector Panduan Pengoperasian - Halaman 30

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Proyektor Epson 835p - PowerLite XGA LCD Projector. Epson 835p - PowerLite XGA LCD Projector 36 halaman. Release of check tool for network projectors v1.00 for windows
Juga untuk Epson 835p - PowerLite XGA LCD Projector: Panduan Pengguna (42 halaman), Pengaturan Cepat (4 halaman), Panduan Pengoperasian (47 halaman), Buletin Dukungan Produk (30 halaman), Panduan Tambahan (1 halaman), Brosur & Spesifikasi (4 halaman), Informasi Produk (21 halaman), Panduan Instalasi (19 halaman), Panduan Pengguna (1 halaman), Ringkasan Teknis (7 halaman), Manual Fungsi (5 halaman), Buletin Dukungan Produk (25 halaman), Buletin Dukungan Produk (38 halaman), Buletin Dukungan Produk (12 halaman), Buletin Dukungan Produk (42 halaman), Buletin Dukungan Produk (22 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (41 halaman), Buletin Dukungan Produk (34 halaman), Buletin Dukungan Produk (38 halaman), Buletin Dukungan Produk (28 halaman), Buletin Dukungan Produk (15 halaman), Buletin Dukungan Produk (22 halaman), Lembar Spesifikasi (4 halaman)

Using the control functions

Procedures for new timer settings

When you click "Add", the following window is

displayed and the new timer settings are applied.

At "Operation", you can carry out the operations of turning the

power on and off and switching the input sources, similarly for

the control buttons on the main window. If you set the input

source switching, the projector's power will turn on at the timer

start time even if it is not on at the time. Because of this, it is not

necessary to make two separate timer settings for turning the

power on and switching the input source.

After completing the timer settings, click [OK].

The timer settings that have been made will be registered and

they can be checked in the displayed timer list.

TIP

You can enable and disable all of the timer settings that have been

registered. Select "Timer" - "Enable" or "Disable" from the "Tool"

menu.