Cisco 7962G - Unified IP Phone VoIP Panduan Administrasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Administrasi untuk Telepon IP Cisco 7962G - Unified IP Phone VoIP. Cisco 7962G - Unified IP Phone VoIP 16 halaman. Unified communications manager 9.0 (sccp and sip)
Juga untuk Cisco 7962G - Unified IP Phone VoIP: Panduan Pengguna (23 halaman), Lembar data (5 halaman), Panduan Pengguna (6 halaman), Panduan Pengguna (4 halaman), Spesifikasi (5 halaman), Panduan Administrasi (12 halaman), Panduan Pengguna (13 halaman), Panduan Pengguna (12 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (6 halaman), Pemecahan Masalah dan Pemeliharaan (27 halaman)

Install Cisco Unified IP Phones

Enable Headset Hookswitch Control

Procedure

Step 1

Choose Device > Phone and locate the phone you want to modify.

Step 2

In the Phone Configuration window, select Enable for Headset Hookswitch Control.

External Device Use

Cisco recommends the use of good quality external devices, such as speakers, microphones, and headsets that

are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals.

Depending on the quality of these devices and their proximity to other devices, such as mobile phones or

two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or

more of the following actions:

• Move the external device away from the source of the RF or AF signals.

• Route the external device cables away from the source of the RF or AF signals.

• Use shielded cables for the external device, or use cables with a better shield and connector.

• Shorten the length of the external device cable.

• Apply ferrites or other such devices on the cables for the external device.

Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external

devices, cables, and connectors. The system performs adequately when suitable devices are attached with

good quality cables and connectors.

Caution

In European Union countries, use only external headsets that are fully compliant with the EMC Directive

[89/336/EC].

Install Cisco Unified IP Phones

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See

Unified IP Phone Cable Installation, on page 7

Note

Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before

using external devices, read

Before You Begin

Remove the hookswitch clip (see

Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco

Unified Communications Manager 9.0 (SCCP and SIP)

for a graphical representation of the connections.

External Device Use, on page 6

Handset, on page

3) from the cradle area.

Cisco Unified IP Phones Installation

for safety and performance information.

Cisco