Cisco 7962G - Unified IP Phone VoIP 관리 매뉴얼 - 페이지 6

{카테고리_이름} Cisco 7962G - Unified IP Phone VoIP에 대한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7962G - Unified IP Phone VoIP 16 페이지. Unified communications manager 9.0 (sccp and sip)
Cisco 7962G - Unified IP Phone VoIP에 대해서도 마찬가지입니다: 사용자 설명서 (23 페이지), 데이터시트 (5 페이지), 사용자 설명서 (6 페이지), 사용자 설명서 (4 페이지), 사양 (5 페이지), 관리 매뉴얼 (12 페이지), 사용자 설명서 (13 페이지), 사용자 설명서 (12 페이지), 빠른 참조 매뉴얼 (2 페이지), 사용자 설명서 (6 페이지), 문제 해결 및 유지 관리 (27 페이지)

Cisco 7962G - Unified IP Phone VoIP 관리 매뉴얼

Install Cisco Unified IP Phones

Enable Headset Hookswitch Control
Procedure
Step 1
Choose Device > Phone and locate the phone you want to modify.
Step 2
In the Phone Configuration window, select Enable for Headset Hookswitch Control.
External Device Use
Cisco recommends the use of good quality external devices, such as speakers, microphones, and headsets that
are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices, such as mobile phones or
two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or
more of the following actions:
• Move the external device away from the source of the RF or AF signals.
• Route the external device cables away from the source of the RF or AF signals.
• Use shielded cables for the external device, or use cables with a better shield and connector.
• Shorten the length of the external device cable.
• Apply ferrites or other such devices on the cables for the external device.
Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external
devices, cables, and connectors. The system performs adequately when suitable devices are attached with
good quality cables and connectors.
Caution
In European Union countries, use only external headsets that are fully compliant with the EMC Directive
[89/336/EC].
Install Cisco Unified IP Phones
You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See
Unified IP Phone Cable Installation, on page 7
Note
Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before
using external devices, read
Before You Begin
Remove the hookswitch clip (see
Cisco Unified IP Phone 7941G, 7941G-GE, 7942G, 7961G, 7961G-GE, and 7962G Administration Guide for Cisco
Unified Communications Manager 9.0 (SCCP and SIP)
6
for a graphical representation of the connections.
External Device Use, on page 6
Handset, on page
3) from the cradle area.
Cisco Unified IP Phones Installation
for safety and performance information.
Cisco