Cisco 8851 Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco 8851. Cisco 8851 11 halaman. Mpp
Juga untuk Cisco 8851: Catatan Rilis (24 halaman), Panduan Pengguna (15 halaman), Panduan Pengguna (16 halaman), Panduan Referensi Cepat (7 halaman), Fitur (16 halaman), Panduan Memulai dengan Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Cepat (2 halaman), Panduan Pengguna (24 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (20 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pengguna (28 halaman), Panduan Utama Migrasi Firmware (31 halaman), Panduan Pengguna (30 halaman), Panduan Pengguna (29 halaman), Manual (44 halaman), Manual (13 halaman), Manual (14 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi (39 halaman), Manual (5 halaman), Panduan Memulai Cepat (2 halaman), Panduan Singkat (2 halaman), Panduan Referensi Cepat (3 halaman), Panduan Memulai Cepat (2 halaman), Panduan Konfigurasi Ulang (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (6 halaman), Manual (22 halaman), Manual (22 halaman), Panduan Memulai Cepat (2 halaman), Memulai (2 halaman), Manual (48 halaman), Panduan Pengguna (40 halaman), Panduan Referensi Cepat (7 halaman), Mulai Cepat (2 halaman), Panduan Referensi Cepat (8 halaman)

- Example of a Hostname: tftp://voip.bicomsystems.com/$MA.cfg

- Example of an IP Address: tftp://10.1.70.150/$MA.cfg

Click Submit and wait for 35 seconds. The phone may reboot.

The auto-provisioning process will start during the phone's reboot process. The phone will pick

up an appropriate configuration file from PBXware. If everything is done as described above,

you should have successfully registered your phone to PBXware.

HTTP & HTTPS

This section describes how to use HTTP & HTTPS protocol in order to register the Cisco phone.

NOTE:

Your PBXware needs to be configured correctly for HTTP to work. Please make sure

that HTTP username and HTTP passwords are set in the auto-provisioning section in 'Settings' -

> 'Servers/Tenants' -> 'Server/Tenant Name'.

Please contact your PBXware administrator. Bicom Systems can provide a service to set this up

for you.

In the Profile Rule field, enter the following:

- Example of a Hostname using HTTP: [--uid username --pwd

password]http://voip.bicomsystems.com/prov/$MA.cfg

- Example of a Hostname using HTTPS: [--uid username --pwd

password]https://voip.bicomsystems.com/prov/$MA.cfg

- Example of an IP Address using HTTP: [--uid username --pwd

password]http://10.1.70.150/prov/$MA.cfg

- Example of an IP Address using HTTPS: [--uid username --pwd

password]https://10.1.70.150/prov/$MA.cfg