Cisco 8851 Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Telepon IP Cisco 8851. Cisco 8851 11 halaman. Mpp
Juga untuk Cisco 8851: Catatan Rilis (24 halaman), Panduan Pengguna (15 halaman), Panduan Pengguna (16 halaman), Panduan Referensi Cepat (7 halaman), Fitur (16 halaman), Panduan Memulai dengan Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Cepat (2 halaman), Panduan Pengguna (24 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (20 halaman), Panduan Memulai Cepat (2 halaman), Panduan Pengguna (28 halaman), Panduan Utama Migrasi Firmware (31 halaman), Panduan Pengguna (30 halaman), Panduan Pengguna (29 halaman), Manual (44 halaman), Manual (13 halaman), Manual (14 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi (39 halaman), Manual (5 halaman), Panduan Memulai Cepat (2 halaman), Panduan Singkat (2 halaman), Panduan Referensi Cepat (3 halaman), Panduan Memulai Cepat (2 halaman), Panduan Konfigurasi Ulang (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (6 halaman), Manual (22 halaman), Manual (22 halaman), Panduan Memulai Cepat (2 halaman), Memulai (2 halaman), Manual (48 halaman), Panduan Pengguna (40 halaman), Panduan Referensi Cepat (7 halaman), Mulai Cepat (2 halaman), Panduan Referensi Cepat (8 halaman)

Cisco 8851 Panduan Pengguna
(*x.|**x.|*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxx|xxxxxxxxxxxx.)
Click the Submit button.
You will have to wait some time for the phone to reboot. If everything is done as described
above, you should have successfully registered your phone to PBXware.

Auto Provisioning

This section describes how to set UAD settings, create a PBXware Extension and register the
phone using DHCP or Static IP address.
The following topics are covered:
UAD Settings
Creating an Extension
Registering a Phone
UAD Settings
UAD settings
Log in to the PBXware's web administration interface
Open a new browser window and enter the IP address in order to access the PBXware's web
administration login screen. Example: http://192.168.1.10.
Log in to PBXware with the e-mail address and password.
UAD settings
Navigate to Settings: UAD.
Make sure Cisco UAD is enabled. To check the UAD status, click the Edit icon corresponding
to the Cisco phone.
Make sure Status is set to Active, Auto provisioning is set to Yes, and DHCP is set to Yes.
Click the Save button to save changes.
Creating an Extension
Creating Extension
Add an Extension