Cisco 12000 - Series Chassis Modular Expansion Base Manual Petunjuk Penggantian - Halaman 34
Jelajahi secara online atau unduh pdf Manual Petunjuk Penggantian untuk Router Jaringan Cisco 12000 - Series Chassis Modular Expansion Base. Cisco 12000 - Series Chassis Modular Expansion Base 40 halaman. Internet router line card failures
Juga untuk Cisco 12000 - Series Chassis Modular Expansion Base: Lembar data (9 halaman), Panduan Ikhtisar (6 halaman), Panduan Pemecahan Masalah Perangkat Keras (18 halaman)
Halaman Cetak
Regulatory, Compliance, and Safety Information
Reinstall the line card in the card cage as described earlier in this publication and perform another
Step 3
installation check.
If the router fails to restart properly after several attempts and you are unable to resolve the problem,
access Cisco.com or contact your Cisco service representative for assistance. Before calling, however,
make note of any console error messages, unusual LED states, or other router indications or behaviors
that might help to resolve the problem.
Regulatory, Compliance, and Safety Information
This section includes regulatory, compliance, and safety information in the following sections:
•
•
Translated Safety Warnings and Agency Approvals
The complete list of translated safety warnings and agency approvals is available in the Regulatory
Compliance and Safety Information for Cisco 12000 Series Internet Routers publication.
(Document Number 78-4347-xx.)
Electromagnetic Compatibility Regulatory Statements
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case users will be
required to correct the interference at their own expense.
Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A digital devices. In that event, your right to use the
equipment may be limited by FCC regulation and you may be required to correct any interference to
radio or television communication at your own expense.
You can determine whether your equipment is causing interference by turning it off. If the interference
stops, it was probably caused by the Cisco equipment or one of its peripheral devices. If the equipment
causes interference to radio or television reception, try to correct the interference by using one or more
of the following measures:
•
•
Cisco 12000 Series Router Memory Replacement Instructions
34
Translated Safety Warnings and Agency Approvals
Electromagnetic Compatibility Regulatory Statements
Turn the television or radio antenna until the interference stops.
Move the equipment to one side or the other of the television or radio.
78-4338-16