Acdeos AXS-MOCR Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Sistem Pengangkatan Acdeos AXS-MOCR. Acdeos AXS-MOCR 10 halaman.

AXS – MOCR manual

6 Mounting / Installation

The installation must only be done by a company that is well known with bodybuilding or modifying

vehicles, which has the trained technical staff to do this job.

The ramp is designed to be fitted direct under the bus floor, where the bus floor is a 15 mm Alucore

sandwich panel.

There should be a hole in the main chassis bar from the vehicle leaving enough space to fit the ramp.

Ramp should be supported at the front end with a steel part from the vehicle floor.

If the front edge of the ramp is made to an integral part of the chassis, it will be of the responsibility of

the vehicle builder.

The Bus floor should be fitted on top of the cassette from the ramp with an PU glue.

The top of the cassette has to be closed complete to prevent dirt getting in the cassette.

The cassette should be supported by the main vehicle chassis bar for strength and stiffness. It is

recommended to use PU glue between the cassette and the chassis bar.

Vehicle builder will be responsible for the total strength and stiffness of the complete installation.

The door will be supplied separate from the cassette. The door should be fitted at the cassette when

the vehicle is nearly finished to prevent damage on the paint.

We recommend to place an anti slip foil on top of the door as this is used as step edge.

Flooring materials should not go under the door. We recommend using an aluminum floor edge profile

between the door and the flooring.

If you have any question: contact the supplier of the ramp.

The repair of the ramp is simple and can be done with the normal available workshop equipment.

The ramp can be removed from the cassette by

removing the buffer block at the side of the ramp.

Once they are removed the ramp platform can be

removed from the cassette.

Than small parts can be replaced.

Slide the platform in the cassette and place the

buffer blocks back in place.

The AXS - Ramp is made of durable materials which all can be recycled. All different materials can

easily be separated from each other for separate recycling.

MOCR RAMP Manual