ページを印刷するAXS – MOCR manual
6 Mounting / Installation
The installation must only be done by a company that is well known with bodybuilding or modifying
vehicles, which has the trained technical staff to do this job.
The ramp is designed to be fitted direct under the bus floor, where the bus floor is a 15 mm Alucore
sandwich panel.
There should be a hole in the main chassis bar from the vehicle leaving enough space to fit the ramp.
Ramp should be supported at the front end with a steel part from the vehicle floor.
If the front edge of the ramp is made to an integral part of the chassis, it will be of the responsibility of
the vehicle builder.
The Bus floor should be fitted on top of the cassette from the ramp with an PU glue.
The top of the cassette has to be closed complete to prevent dirt getting in the cassette.
The cassette should be supported by the main vehicle chassis bar for strength and stiffness. It is
recommended to use PU glue between the cassette and the chassis bar.
Vehicle builder will be responsible for the total strength and stiffness of the complete installation.
The door will be supplied separate from the cassette. The door should be fitted at the cassette when
the vehicle is nearly finished to prevent damage on the paint.
We recommend to place an anti slip foil on top of the door as this is used as step edge.
Flooring materials should not go under the door. We recommend using an aluminum floor edge profile
between the door and the flooring.
If you have any question: contact the supplier of the ramp.
7 Repair
The repair of the ramp is simple and can be done with the normal available workshop equipment.
7.1 Disassembly
The ramp can be removed from the cassette by
removing the buffer block at the side of the ramp.
Once they are removed the ramp platform can be
removed from the cassette.
Than small parts can be replaced.
7.2 Assembly
Slide the platform in the cassette and place the
buffer blocks back in place.
8 Environment
The AXS - Ramp is made of durable materials which all can be recycled. All different materials can
easily be separated from each other for separate recycling.
MOCR RAMP Manual
5