CAB e4 Panduan Operator - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Operator untuk Pembuat label CAB e4. CAB e4 18 halaman. Barcode/label printer the economy class
Juga untuk CAB e4: Panduan Operator (18 halaman)
Halaman Cetak
4
Operation
10
4.1 Operator Controls
Power Switch
The power switch is located on the left-hand side of the printer.
Position 0:
Off
Position I:
On
DIP Switches
i
Switch off the printer before setting the DIP switches.
DIP switch
Functions
1
ON:
OFF:
2
ON:
OFF:
3
Reserved
4
Reserved
5
Reserved
6
Reserved
7, 8
8 | 7
0 | 0 – 9600,n,8,1
0 | 1 – 19200,n,8,1
1 | 0 – 38400,n,8,1
1 | 1 – 57600,n,8,1
Control Panel
The operating panel consists of three LEDs and three multifunction buttons.
LEDs
They indicate the status of the printer.
READY
Lights
MEDIA
Lights
Flashes simultaneously with READY
Flashes
RIBBON
Lights
Off
Flashes simultaneously with READY
Multifunction buttons
The printer is either in standard or system mode.
Normal mode
PAUSE
Pause print job
Continue print job after pause
FEED
Feed one label
CANCEL
Cancel print job
Continue printing after rectifying fault
Direct thermal print
Thermal transfer print
Enables back feed (tear-off mode)
Disables back feed
Remarks
Print settings
Default: OFF
Back feed (tear-off mode)
Default: OFF
Always OFF
Always OFF
Always OFF
Always OFF
Serial interface RS 232
Baud rate setting
0: OFF, 1: ON
Default: 00
Standard printer status
Standard printer status
Media roll has run out
PAUSE status
Standard printer status
Direct thermal printing
(no transfer ribbon inserted)
Ribbon roll has run out
System mode
Self-test
Calibrating the media sensor
Reset
10
ON
OFF