CAB e4 Panduan Operator - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Operator untuk Pembuat label CAB e4. CAB e4 18 halaman. Barcode/label printer the economy class
Juga untuk CAB e4: Panduan Operator (18 halaman)
Halaman Cetak
3
Getting Started
3.6 Loading the Transfer Ribbon
Warning!
Risk of material damage.
When inserting the transfer ribbon ensure that the coated side faces the labels, as otherwise the printhead
!
can become soiled.
Ensure that the media is winding in the same direction as shown in the illustration.
1
1
1 Ribbon spindle
2 Ribbon roll
3 Empty transfer ribbon core
4 Ribbon supply holder
1.
Open the cover.
2.
Release the printhead module and swing it up.
3.
Slide the ribbon roll (2) onto one of the ribbon spindles (1), and put the empty core (3) on the other spindle (1).
If the roll is less than 110 mm wide, position the roll and core in the middle of the spindle.
4.
Pull out the knob (5), insert the ribbon roll (2) together with the spindle into the supply holder (4), allow the knob to slot in
again.
When inserting the two spindles (1) ensure that the wider side is placed in the respective holder (4, 7), and slots in.
i
5.
Attach the end of the ribbon to the empty core (3) with adhesive tape.
6.
Lead the ribbon round the printhead module as shown in the illustration.
7.
Pull out the knob (6), insert the core and spindle into the rewind holder (7), allow the knob to slot in again.
8.
Turn knob (6) clockwise to take up the slack in the ribbon.
9.
Close the printhead module by pressing it down until it locks in.
10.
Close the cover.
2
3
7
4
2
3
6
5 Ribbon loading knob
6 Ribbon rewind knob
7 Ribbon rewind holder
9
5