Cisco SGE2000 Panduan Konfigurasi - Halaman 25
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Router Jaringan Cisco SGE2000. Cisco SGE2000 46 halaman. Nx-os fabric extender
Juga untuk Cisco SGE2000: Panduan Instalasi Cepat (32 halaman), Catatan Rilis (16 halaman), Lembar data (5 halaman), Panduan Peningkatan Firmware (5 halaman), Panduan Memulai Cepat (2 halaman)
Halaman Cetak
Configuring the Fabric Extender
Enabling the Fabric Extender Feature Set
You can enable the installed Fabric Extender feature set in any VDC on the device.
Before You Begin
Ensure that you have installed the Fabric Extender feature set in the default VDC.
Ensure that you are in the correct VDC or use the switchto vdc command.
SUMMARY STEPS
1. configure terminal
2. feature-set fex
3. exit
DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
feature-set fex
Example:
switch(config)# feature-set fex
Step 3
exit
Example:
switch(config)# exit
switch#
Disallowing the Fabric Extender Feature Set
By default, when you install the Fabric Extender feature set, it is allowed in all VDCs. You can disallow the
installed Fabric Extender feature set in a specific VDC on the device.
Before You Begin
Ensure that you have installed the feature set in the default VDC.
OL-25816-02
Purpose
Enters configuration mode.
Enables the Fabric Extender feature set. The feature set must be installed
before it shows as an option to this command.
To disable the Fabric Extender feature set, use the no feature-set fex
command. Before you can disable a feature set, you must install the feature
set in the default VDC.
The no feature-set fex command might take some time to complete
Note
if the size of the configuration is very large. The command cleans
up all of the configurations associated with the Fabric Extender
feature set.
Exits configuration mode.
Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide
Managing the Fabric Extender Feature Set
15