Cisco SGE2000 구성 매뉴얼 - 페이지 25

{카테고리_이름} Cisco SGE2000에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SGE2000 46 페이지. Nx-os fabric extender
Cisco SGE2000에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (32 페이지), 릴리스 노트 (16 페이지), 데이터시트 (5 페이지), 펌웨어 업그레이드 매뉴얼 (5 페이지), 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄
Cisco SGE2000 구성 매뉴얼
Configuring the Fabric Extender

Enabling the Fabric Extender Feature Set

You can enable the installed Fabric Extender feature set in any VDC on the device.
Before You Begin
Ensure that you have installed the Fabric Extender feature set in the default VDC.
Ensure that you are in the correct VDC or use the switchto vdc command.
SUMMARY STEPS
1. configure terminal
2. feature-set fex
3. exit
DETAILED STEPS
Command or Action

Step 1

configure terminal
Example:
switch# configure terminal
switch(config)#
Step 2
feature-set fex
Example:
switch(config)# feature-set fex
Step 3
exit
Example:
switch(config)# exit
switch#

Disallowing the Fabric Extender Feature Set

By default, when you install the Fabric Extender feature set, it is allowed in all VDCs. You can disallow the
installed Fabric Extender feature set in a specific VDC on the device.
Before You Begin
Ensure that you have installed the feature set in the default VDC.
OL-25816-02
Purpose
Enters configuration mode.
Enables the Fabric Extender feature set. The feature set must be installed
before it shows as an option to this command.
To disable the Fabric Extender feature set, use the no feature-set fex
command. Before you can disable a feature set, you must install the feature
set in the default VDC.
The no feature-set fex command might take some time to complete
Note
if the size of the configuration is very large. The command cleans
up all of the configurations associated with the Fabric Extender
feature set.
Exits configuration mode.
Cisco Nexus 2000 Series NX-OS Fabric Extender Software Configuration Guide
Managing the Fabric Extender Feature Set
15