Cisco WUMC710 Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Router Jaringan Cisco WUMC710. Cisco WUMC710 17 halaman. 802.11ac
Juga untuk Cisco WUMC710: Panduan Pengguna (17 halaman), Panduan Instalasi Cepat (17 halaman)
Halaman Cetak
Linksys WUMC710
Troubleshooting
WUMC710
Your computer or other wired, Ethernet device cannot communicate with the
wireless router.
1. Access the bridge's browser-based utility
2. On the Basic Wireless Settings screen, make sure the Network Name (SSID)
matches the name of your wireless network
3. Make sure the security settings (WPA, WPA2, or WEP) match the security
settings of your wireless network
The bridge's IP address needs to be changed.
If the bridge is connected to a network with a DHCP server (usually the network
router), then the bridge will obtain its IP address from the DHCP server If
there is no DHCP server, then the bridge will use its default, static IP address,
10.100.1.1
If you want the bridge to always use a static IP address, then follow these
instructions:
1. Access the bridge's browser-based utility
2. Click the Network Setup tab
3. From the Network Connection Type drop-down menu, select Static IP
4. Complete the Static IP Address, Subnet Mask, and Default Gateway fields
5. Click Save Settings
The bridge-enabled computer or other wired, Ethernet device will not
communicate with another wireless-enabled device (such as a computer or
printer).
Check the following:
Make sure the wireless-enabled device is on the same wireless network
•
as the computer or other wired, Ethernet device connected to the bridge
Make sure that the same Network Name (SSID) is used for all devices on
•
the wireless network
Make sure all devices are on the same IP network, using compatible IP
•
addresses
The browser-based utility does not accept your password.
Check the following:
The password is case-sensitive Make sure that you are using the correct
•
case(s) when entering the password
If you forget your password, you can reset the bridge to its factory
•
defaults
Press and hold the bridge's Reset button for approximately five seconds;
the password will be reset to its factory default, admin All other bridge
settings will be reset to the factory defaults as well (To access the
browser-based utility, enter admin in the Password field )
After you make changes through the browser-based utility, the new settings
are not displayed on-screen.
On your web browser, click Refresh If the new settings are not displayed, then
follow these instructions:
1. Unplug the power adapter from the bridge
2. Wait five seconds, and then plug the power adapter back into the bridge
3. On your web browser, click Refresh
WEB
If your questions are not addressed here, refer to the Linksys
website at Linksys.com/support
Troubleshooting
14
14