Cisco WUMC710 사용자 설명서 - 페이지 15

{카테고리_이름} Cisco WUMC710에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WUMC710 17 페이지. 802.11ac
Cisco WUMC710에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지), 빠른 설치 매뉴얼 (17 페이지)

페이지 인쇄

1. Setup > Basic Setup

Linksys WUMC710

Troubleshooting

WUMC710

Your computer or other wired, Ethernet device cannot communicate with the

wireless router.

1. Access the bridge's browser-based utility

2. On the Basic Wireless Settings screen, make sure the Network Name (SSID)

matches the name of your wireless network

3. Make sure the security settings (WPA, WPA2, or WEP) match the security

settings of your wireless network

The bridge's IP address needs to be changed.

If the bridge is connected to a network with a DHCP server (usually the network

router), then the bridge will obtain its IP address from the DHCP server If

there is no DHCP server, then the bridge will use its default, static IP address,

10.100.1.1

If you want the bridge to always use a static IP address, then follow these

instructions:

1. Access the bridge's browser-based utility

2. Click the Network Setup tab

3. From the Network Connection Type drop-down menu, select Static IP

4. Complete the Static IP Address, Subnet Mask, and Default Gateway fields

5. Click Save Settings

The bridge-enabled computer or other wired, Ethernet device will not

communicate with another wireless-enabled device (such as a computer or

printer).

Check the following:

Make sure the wireless-enabled device is on the same wireless network

•

as the computer or other wired, Ethernet device connected to the bridge

Make sure that the same Network Name (SSID) is used for all devices on

•

the wireless network

Make sure all devices are on the same IP network, using compatible IP

•

addresses

The browser-based utility does not accept your password.

Check the following:

The password is case-sensitive Make sure that you are using the correct

•

case(s) when entering the password

If you forget your password, you can reset the bridge to its factory

•

defaults

Press and hold the bridge's Reset button for approximately five seconds;

the password will be reset to its factory default, admin All other bridge

settings will be reset to the factory defaults as well (To access the

browser-based utility, enter admin in the Password field )

After you make changes through the browser-based utility, the new settings

are not displayed on-screen.

On your web browser, click Refresh If the new settings are not displayed, then

follow these instructions:

1. Unplug the power adapter from the bridge

2. Wait five seconds, and then plug the power adapter back into the bridge

3. On your web browser, click Refresh

WEB

If your questions are not addressed here, refer to the Linksys

website at Linksys.com/support

Troubleshooting