DigitaLinx DL-UHDRC70 Panduan Pemasangan Cepat - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemasangan Cepat untuk Pemanjang DigitaLinx DL-UHDRC70. DigitaLinx DL-UHDRC70 8 halaman. Hdbaset extender
Juga untuk DigitaLinx DL-UHDRC70: Panduan Pemilik (16 halaman), Panduan Pemasangan Cepat (8 halaman), Panduan Pemasangan Cepat (6 halaman)
Halaman Cetak
1. Verify all components included are present before installation.
2. Connect an HDMI source device to the HDMI IN port on the transmitter using an
HDMI cable
3. Connect a display device to the HDMI OUT port on the receiver using an HDMI
cable
4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between
the transmitter and the receiver. TIA/EIA-568B straight-through wiring connections
must be used with the DL-UHDRC70
5. Connect control system and devices to the RS232 port on the transmitter and
receiver for serial pass through.
6. Both the transmitter and receiver has an IR IN and an IR OUT for bi-directional
IR control. Connect one device with an IR emitter to the IR OUT then the other
device should be connected with an IR eye into IR IN to pass IR control
7. Apply power to DL-UHDRC70 by connecting the 18V power supply to either the
transmitter or receiver. Powering one unit will power the other via PoC
Note: On the front panel of the TX/RX check to make sure the Power, Status,
HDCP & Link lights are all illuminated on both units. This will indicate a successful
connection with a lit HDCP light illustrating the presence of encryption within the signal.
Power and Link are static lights and Status should be blinking.
Connectivity Instructions
DL-UHDRC70 Quick Guide