- ページ 5

エクステンダー DigitaLinx DL-UHDRC70のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。DigitaLinx DL-UHDRC70 8 ページ。 Hdbaset extender
DigitaLinx DL-UHDRC70 にも：オーナーズマニュアル (16 ページ), クイック・インストール・マニュアル (8 ページ), クイック・インストール・マニュアル (6 ページ)

1. Verify all components included are present before installation.

2. Connect an HDMI source device to the HDMI IN port on the transmitter using an

HDMI cable

3. Connect a display device to the HDMI OUT port on the receiver using an HDMI

cable

4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between

the transmitter and the receiver. TIA/EIA-568B straight-through wiring connections

must be used with the DL-UHDRC70

5. Connect control system and devices to the RS232 port on the transmitter and

receiver for serial pass through.

6. Both the transmitter and receiver has an IR IN and an IR OUT for bi-directional

IR control. Connect one device with an IR emitter to the IR OUT then the other

device should be connected with an IR eye into IR IN to pass IR control

7. Apply power to DL-UHDRC70 by connecting the 18V power supply to either the

transmitter or receiver. Powering one unit will power the other via PoC

Note: On the front panel of the TX/RX check to make sure the Power, Status,

HDCP & Link lights are all illuminated on both units. This will indicate a successful

connection with a lit HDCP light illustrating the presence of encryption within the signal.

Power and Link are static lights and Status should be blinking.

Connectivity Instructions

DL-UHDRC70 Quick Guide