DigitaLinx DL-UHDRC70 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemanjang DigitaLinx DL-UHDRC70. DigitaLinx DL-UHDRC70 16 halaman. Hdbaset extender
Juga untuk DigitaLinx DL-UHDRC70: Panduan Pemasangan Cepat (8 halaman), Panduan Pemasangan Cepat (8 halaman), Panduan Pemasangan Cepat (6 halaman)

Halaman Cetak

DL-UHDRC70 Owners Manual

Connecting IR Control

The DL-UHDRC70 is capable of transmitting bi-directional IR signals through the HDBaseT circuit. The

UHDRC70 comes with 2 IR receivers (eye) and 2 IR emitters (flashers) so you can control devices from either end

of the extender circuit.

Passing IR Signals:

The DL-

to any of the electronics, the extenders should be powered off while inserting or removing any

IR components. Inserting an IR transmitter into the IR IN port may damage the IR circuit for that

Source Device Control using IR

Attach the IR emitter to the IR receiver of the source device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-UHDRC70 transmitter. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port

of the DL-UHDRC70 receiver. Point the source device IR remote at the display location where the IR receiver is

located, IR signals will now travel through HDBaseT to the DL-UHDRC70 transmitter side where the IR emitter is

attached to the source device.

Remote Display using IR

Attach the IR emitter to the IR receiver of the display device, insert the TS 3.5 mm plug of the emitter to the IR

OUT port of the DL-UHDRC70 receiver. Insert the TS 3.5 mm plug of the IR receiver (eye) to the IR IN port of the

DL-UHDRC70 transmitter. Point the source device IR remote at the source device location where the IR receiver

is located, IR signals will now travel through HDBaseT to the DL-UHDRC70 receiver side where the IR emitter is

attached to the display device.

Source / Display Control from Control System

To pass 3rd party IR system signals through the DL-HD70, such as a control system, connect the TS connector

of the IR-AC coupling cable (provided) to the IR output port of the control system and connect the TRS connec-

tor of the IR-AC cable to the IR IN to either transmitter or receiver of the DL-UHDRC70.

Tx or Rx Extender IR Input

UHDRC70

is capable of passing IR signals between 33 and 55 KHz. To prevent damage

Tip: +5V DC

Ring: IR Signal

Sleeve: Ground (GND)

IR Signal

Note: Voltage on Tip from RX may be diﬀernt for non Liberty Devices

+5V DC Lifted

Ground (GND)

DL-

Sleeve: Ground (GND)

Tip: IR Signal

To Control system or

IR hub output