DigitaLinx DL-UHDILC Panduan Pemilik - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Beralih DigitaLinx DL-UHDILC. DigitaLinx DL-UHDILC 17 halaman.
Juga untuk DigitaLinx DL-UHDILC: Panduan Pemasangan Cepat (5 halaman)
Halaman CetakDL-UHDILC Owners Manual
Configuring System Timeout
By default system timeout is set to 3 minutes. After there is no present video signal passing through the DL-UHDILC
for 3 minutes the system will transmit the Power off command to the display or projector and trigger the second
relay port switch.
To change the default system timeout, choose the desired time from the Delay drop down menu underneath the
Power off command field.
Click the Send button adjacent to the Power off field. If upload is successful a green light next to the Send button
will illuminate and a pop up window will confirm a successful upload.
Setting Relay Modes
By default the relay ports are set to latching, with the configuration software tool you can change the mode to
momentary and then set the momentary switch time as well.
To change the default relay mode to momentary, choose the Momentary selection from the Relay Mode drop
down menu, then set the time (1-10 seconds) in the Time field.
Click the Set button. If upload is successful a green light next to the Set button will illuminate and a pop up window
will confirm a successful upload.
To change back to latching relay mode, choose the Latch selection from the Relay Mode drop down menu, then
click Set button to make the change.
15