DigitaLinx DL-UHDILC Owner's Manual - Page 15

Browse online or download pdf Owner's Manual for Switch DigitaLinx DL-UHDILC. DigitaLinx DL-UHDILC 17 pages.
Also for DigitaLinx DL-UHDILC: Quick Install Manual (5 pages)

Print Page

DL-UHDILC Owners Manual

Configuring System Timeout

By default system timeout is set to 3 minutes. After there is no present video signal passing through the DL-UHDILC

for 3 minutes the system will transmit the Power off command to the display or projector and trigger the second

relay port switch.

To change the default system timeout, choose the desired time from the Delay drop down menu underneath the

Power off command field.

Click the Send button adjacent to the Power off field. If upload is successful a green light next to the Send button

will illuminate and a pop up window will confirm a successful upload.

Setting Relay Modes

By default the relay ports are set to latching, with the configuration software tool you can change the mode to

momentary and then set the momentary switch time as well.

To change the default relay mode to momentary, choose the Momentary selection from the Relay Mode drop

down menu, then set the time (1-10 seconds) in the Time field.

Click the Set button. If upload is successful a green light next to the Set button will illuminate and a pop up window

will confirm a successful upload.

To change back to latching relay mode, choose the Latch selection from the Relay Mode drop down menu, then

click Set button to make the change.