Argent Data Systems ADS-SR1 Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengulang Argent Data Systems ADS-SR1. Argent Data Systems ADS-SR1 20 halaman. Simplex repeater

Halaman Cetak

Command Reference

All normal commands start with '##', followed by at least two digits. If the unit

is locked (either because the lock command '##00' was entered or because the

auto-lock function was enabled and the timer expired), no commands will be

accepted until '##' and the 3-digit security code have been received. For

example, if the code is '123', entering '##123' unlocks the unit.

If the repeater has trouble receiving commands, try adjusting the audio input

level. Each time a valid DTMF tone is received, the red LED will momentarily

turn off. When entering long commands, watch the LED to ensure each key

press is received properly.

The ADS-SR1 responds to commands with four distinct tone sequences:

High triple-beep – 'Ok - Command was accepted.

High-high-low – 'Negative' - Command was accepted, with negative results.

High-low – 'Error' - Unknown command, or invalid entry.

Low-low – 'Locked' - The security code must be entered first.

Entering Times

For most commands requiring units of time, you can use one of three entry

modes:

MM – Two digit value in minutes (e.g., '10' = 10 minutes)

SSS – Three digit value in seconds (e.g., '030' = 30 seconds)

HHMM – Hours and minutes, up to 12 hours (e.g., '0130' = 1 hour 30 minutes)

A quick reference sheet is included at the end of this manual. We strongly

recommend cutting out this sheet, folding it, and storing it in the ADS-SR1's

battery compartment. If you plan to store the unit for long periods with lithium

batteries installed, use the back of the sheet to track battery replacement dates.