Epson AcuLaser CX11NF Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Semua dalam Satu Printer Epson AcuLaser CX11NF. Epson AcuLaser CX11NF 17 halaman. Multi-function colour laser printers
Juga untuk Epson AcuLaser CX11NF: Operasi Dasar Gude (26 halaman), Spesifikasi (4 halaman), Setup Manual (32 halaman), Mulai dari Sini Manual (8 halaman), Spesifikasi (2 halaman), Panduan Tambahan (6 halaman), Memperbarui (1 halaman), Buletin Dukungan Produk (5 halaman), Spesifikasi (4 halaman)

Halaman Cetak
Epson AcuLaser CX11NF Panduan Pengguna
Epson AcuLaser CX11N/CX11NF
Caution:
Do not touch the belt on the top of the photoconductor or the
blue area; otherwise, print quality may decrease.
Avoid exposing the photoconductor to light any longer than
necessary.
Do not touch any other components inside the CX11N.
9. Hold the photoconductor by its handle and insert it into
the slots marked with blue arrows inside the CX11N. Push
it in until it clicks into place.
Warning:
Be careful not to touch the fuser, which is marked CAUTION
HIGH TEMPERATURE. If you have been using the CX11N
recently, the fuser may be very hot.
10. Flip down the orange lever, then close cover B.
11. Slide out and flip open the output tray extension, if
necessary.
14
Epson AcuLaser CX11N/CX11NF
-
12. Slowly push down the scanner to its original position.

Cleaning the CX11N

If the CX11N's outer case is dirty or dusty, turn off the
CX11N and clean it with a soft cloth moistened with mild
detergent.
Caution:
Never use alcohol or paint thinner to clean the CX11N; these
chemicals can damage the components and the case. Be careful not
to get water on the CX11N mechanisms or any electrical
components.
To clean other parts of the CX11N, see these sections:
❏ "Cleaning the Pickup Roller" (below)
❏ "Cleaning the Print Head" on page 15
❏ "Cleaning the Exposure Window and Document Table" on
page 15
❏ "Cleaning the ADF Pickup Rollers (CX11NF Only)" on
page 16

Cleaning the Pickup Roller

1. Make sure the CX11N is turned off and that the power cord
is not plugged into an outlet.
2. Open the MP tray cover and remove any loaded paper.
8/05