Cisco ASR1006 - ASR 1006 Modular Expansion Base Panduan Pemasangan Perangkat Keras - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Titik Akses Nirkabel Cisco ASR1006 - ASR 1006 Modular Expansion Base. Cisco ASR1006 - ASR 1006 Modular Expansion Base 47 halaman. Lightweight access points
Juga untuk Cisco ASR1006 - ASR 1006 Modular Expansion Base: Panduan Penyebaran (40 halaman)
Halaman Cetak
Figure 11
Cisco ASR 1006 Router AC Power Supply (ASR1013/06-PWR-AC)
5
4
1
AC power supply fan
DB-25 alarm connector
2
Tie-wrap tab
3
AC power supply captive screw
4
5
AC power supply handle
Note
Shielded cables must be used to connect to the DB-25 alarm connector on both the AC and DC power supplies, in order
to comply with the FCC/EN55022/CISPR22 Class A emissions requirements.
Plug the AC power supply cable into the AC power source at your site.
Step 3
Step 4
Place the power supply standby switch in the On (I) position.
This completes the procedure for connecting AC-input power.
Connect DC Power to the Cisco ASR 1006 Router
This section provides instructions for installing the DC power supply into the Cisco ASR 1006 Router. Read the safety warnings
before you begin.
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
Never install an AC power module and a DC power module in the same chassis. Statement 1050
Warning
When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
16
6
7
8
100-240V~ 16-7A
50-60HZ
This unit might have more than
one power supply connection.
All connections must be removed
to de-energize the unit.
3
6
AC power inlet
AC power supply standby switch
7
Protective shielding on both sides of the standby switch
8
AC power supply LEDs
9
— —
9
OUTPUT INPUT INPUT
FAIL
OK
OK
ALARMS
60V
1A MAX
2
1