Cisco WAP125 Panduan Memulai Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco WAP125. Cisco WAP125 13 halaman. Wireless-ac/n dual band desktop access point with poe
Juga untuk Cisco WAP125: Manual (10 halaman), Panduan Memulai Cepat (14 halaman)
Halaman Cetak
Mounting the Cisco WAP125
3
You can place the Cisco WAP125 horizontally on a surface so that it sits on
its four rubber feet, or place it vertically on a desktop by using the stand on
its left side.
To place the Cisco WAP125 vertically on a desktop, follow these steps:
Locate the left side panel of the Cisco WAP125, and rotate the stand
S
1
TEP
90 degrees clockwise or anticlockwise.
Place the stand upward so that the Cisco WAP125 stands on a flat
S
2
TEP
desktop.
Placement Tips
• Ambient Temperature—To prevent the Cisco WAP125 from
overheating, do not operate it in an area that exceeds an ambient
temperature of 104°F (40°C).
• Air Flow—Be sure there is adequate air flow around the device.
• Mechanical Loading—The Cisco WAP125 should be level, stable, and
secure to prevent it from sliding or shifting out of position.
Connecting the Cisco WAP125
4
You can perform the initial configuration using either a wired or wireless
connection. The default configuration of the Cisco WAP125 has the Wi-Fi
radio turned on.
To connect the Cisco WAP125 to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch, a router,
S
1
TEP
or a PC.
Connect the other end of the network Ethernet cable to the
S
2
TEP
Ethernet port of the Cisco WAP125.
If PoE is not provided, plug in the supplied power adapter to
S
3
TEP
provide power to the Cisco WAP125.
4
Cisco WAP125 Quick Start Guide