Cisco 7841 Panduan Utama Migrasi Firmware - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Utama Migrasi Firmware untuk Sistem Konferensi Cisco 7841. Cisco 7841 31 halaman. Classroom phone
Juga untuk Cisco 7841: Catatan Rilis (16 halaman), Panduan Memulai Cepat (2 halaman), Panduan Referensi Cepat (4 halaman), Referensi Cepat (4 halaman), Instalasi Cepat & Panduan Pengguna (12 halaman), Panduan Referensi (11 halaman), Panduan Referensi Cepat (7 halaman), Panduan Referensi Cepat (7 halaman), Panduan Pengguna (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Manual (2 halaman), Manual (27 halaman), Manual (43 halaman), Panduan Referensi Cepat (4 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi (39 halaman), Menggunakan (4 halaman), Panduan Pengguna Cepat (2 halaman), Manual (7 halaman), Manual (20 halaman), Panduan Fitur (4 halaman), Panduan Konfigurasi Ulang (2 halaman), Panduan Referensi Pengguna (5 halaman), Kartu Referensi Cepat (2 halaman), Panduan Instalasi Cepat (12 halaman), Panduan Memulai Cepat (2 halaman), Panduan Cepat (3 halaman), Kartu Referensi Cepat (2 halaman), Kartu Referensi Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Referensi Cepat (3 halaman)

After the reboot, the phone has the transitional load installed. You will see "Configuration check in progress" and you may see a

warning "Failed to downloaded configuration data. Contact your administrator." DO NOT CLICK RETRY.

Ignore this warning as it only pertains to Bulk Provisioning. Bulk provisioning is covered in the Appendix. Move to the next step.

11. Determine the IP Address of your phone:

•

Push the Applications button

12. Type the following into your web browser:

13. In your web browser, navigate to Voice -> Provisioning.

14. Scroll down to "Firmware Upgrade" and paste the following into the "Upgrade Rule".

Upgrade Rule:

http://CUCM_ip_address:6970/sipxxxx.11-2-3MPP-398.loads

Unified CM and sipxxxx is the appropriate phone load (either sip78xx or sip88xx). The filename is the same as the file you entered in

Step 8.

(This is a normal MPP image that can be registered to approved 3

Transition Load Authorization Rule:

Press Submit All Changes

Example:

Note: The $MAU is a macro. The phone expands the macro $MAU to its own MAC address in all uppercase and transmits the

expanded request across the wire. The full path of the license file is listed below as reference.

-> Status -> Network Status -> IPv4

http://ip_address_of_phone/admin/advanced

http:// CUCM_ip_address:6970/$MAU.lic

where CUCM_ip_address is the IP address of the

party call control systems).

Page 11 of 30