Epson ET-3710 Mulai di sini
Jelajahi secara online atau unduh pdf Mulai di sini untuk Semua dalam Satu Printer Epson ET-3710. Epson ET-3710 4 halaman.
Halaman Cetak
ET-3710
Start Here
IMPORTANT: Before using this product, make sure you read
these instructions and the safety instructions in the online
User's Guide
.
1
Unpack
Note:
Do not open the ink bottles until you are ready to fill the ink
tanks. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit. Remove all protective materials
from inside the product.
Caution:
Do not touch the flat white cable or the ink tubes and
their translucent cover.
2
Fill ink tanks
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
Caution:
This product requires careful handling of ink. If ink spills,
wipe it off immediately with a damp towel to avoid permanent stains. If
ink gets on your clothes or belongings, it may not come off.
Note:
• Epson cannot guarantee the quality or reliability of third-party ink.
• Use the ink bottles included with the printer to set up the product.
Part of the ink will be used to charge the print head. These bottles
may print fewer pages compared with replacement ink bottles.
1
Open the ink tank cover, then open the cap for the black
ink tank.
2
Unpack the black (BK) ink bottle. Hold the ink bottle
upright and slowly turn the bottle cap to remove it.
Caution:
Do not shake or squeeze the ink bottles. Do not touch
the top of the ink bottle after its cap is removed.
3
Insert the ink bottle into the filling port, as shown below.
Note:
Refer to the color-coded sticker on the ink tank unit to
identify the color of each tank. Do not force the bottles into
position; they are keyed for each color.
4
Wait for the ink to fill the tank.
Do not squeeze the bottle. Ink
flows into the tank and stops
automatically when the ink is
filled to the upper line.
Note:
If ink does not flow from the
bottle, lift and reinsert the bottle.
Caution:
After setup, periodically
inspect the ink level to ensure it is
not below the lowest line on the
tank. Prolonged use when ink is
below the lowest line could damage
the product. See the online User's
Guide for refilling instructions.
5
When the ink tank is full, remove the ink
bottle and replace the bottle cap. Place the
remaining ink aside; you will need it later.
Note:
Do not leave the ink bottle inserted;
otherwise the bottle may be damaged or ink
may leak.