Epson ET-3710 여기에서 시작

{카테고리_이름} Epson ET-3710에 대한 여기에서 시작을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ET-3710 4 페이지.

페이지 인쇄

ET-3710

Start Here

IMPORTANT: Before using this product, make sure you read

these instructions and the safety instructions in the online

User's Guide

Unpack

Note:

Do not open the ink bottles until you are ready to fill the ink

tanks. The ink bottles are vacuum packed to maintain reliability.

Remove all protective materials from the product.

Lift up the scanner unit. Remove all protective materials

from inside the product.

Caution:

Do not touch the flat white cable or the ink tubes and

their translucent cover.

Fill ink tanks

Warning:

Keep the ink bottles out of the reach of children and do not

drink the ink.

Caution:

This product requires careful handling of ink. If ink spills,

wipe it off immediately with a damp towel to avoid permanent stains. If

ink gets on your clothes or belongings, it may not come off.

Note:

• Epson cannot guarantee the quality or reliability of third-party ink.

• Use the ink bottles included with the printer to set up the product.

Part of the ink will be used to charge the print head. These bottles

may print fewer pages compared with replacement ink bottles.

Open the ink tank cover, then open the cap for the black

ink tank.

Unpack the black (BK) ink bottle. Hold the ink bottle

upright and slowly turn the bottle cap to remove it.

Caution:

Do not shake or squeeze the ink bottles. Do not touch

the top of the ink bottle after its cap is removed.

Insert the ink bottle into the filling port, as shown below.

Note:

Refer to the color-coded sticker on the ink tank unit to

identify the color of each tank. Do not force the bottles into

position; they are keyed for each color.

Wait for the ink to fill the tank.

Do not squeeze the bottle. Ink

flows into the tank and stops

automatically when the ink is

filled to the upper line.

Note:

If ink does not flow from the

bottle, lift and reinsert the bottle.

Caution:

After setup, periodically

inspect the ink level to ensure it is

not below the lowest line on the

tank. Prolonged use when ink is

below the lowest line could damage

the product. See the online User's

Guide for refilling instructions.

When the ink tank is full, remove the ink

bottle and replace the bottle cap. Place the

remaining ink aside; you will need it later.

Note:

Do not leave the ink bottle inserted;

otherwise the bottle may be damaged or ink

may leak.