Cisco TelePresence SX20 Panduan Memulai - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Sistem Konferensi Cisco TelePresence SX20. Cisco TelePresence SX20 41 halaman. In-room control on touch 10
Juga untuk Cisco TelePresence SX20: Set Cepat (8 halaman), Panduan Memulai (42 halaman), Panduan Referensi Cepat (2 halaman), Set Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (29 halaman), Panduan Pemecahan Masalah (37 halaman), Panduan Informasi Kepatuhan Peraturan dan Keselamatan (9 halaman), Setup Manual (8 halaman), Panduan Pengguna (38 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (37 halaman), Manual (45 halaman), Manual (45 halaman), Lembar Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (5 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (38 halaman), Panduan Memulai (42 halaman), Panduan Referensi (8 halaman), Panduan Memulai (46 halaman)

Halaman Cetak

Cisco TelePresence Video Systems

Contents

Configuration tasks (continued)

Setting the H.323 and SIP parameters

(when not set by a provisioning system)

To get online and ready to place and receive calls, your system

must be set up properly. Your system uses either the H.323

protocol or the SIP protocol for video calls.

Choose one of the following methods to set the H.323 and

SIP parameters:

Touch controller

Remote control

and on screen menu

Web interface

D14639.12 Video Systems Getting Started Guide TC7.0, DECEMBER 2013.

Introduction

User interfaces

Setting date and time

(when not set by a provisioning system)

When setting up your video conference system, you should

check that the date and time settings are correct. Among

other things this information is used to time stamp messages

transmitted to gatekeepers and other network elements.

Choose one of the following methods to set the date and time:

Touch controller

Remote control

and on screen menu

Web interface

Confirguration

Configuration

Setting the menu password

We strongly recommend that you set a password for the

Administrator Settings menu.

This menu, which is available on both the Touch controller and

the remote control, gives access to settings that affect the

behavior of the video conference system.

Choose one of the following methods to set-up the menu

password:

Getting Started Guide

Appendices

Remote control

and on screen menu

Web interface

Contacts