Cisco TelePresence SX20 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Konferensi Cisco TelePresence SX20. Cisco TelePresence SX20 34 halaman. In-room control on touch 10
Juga untuk Cisco TelePresence SX20: Set Cepat (8 halaman), Panduan Memulai (41 halaman), Panduan Memulai (42 halaman), Panduan Referensi Cepat (2 halaman), Set Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (29 halaman), Panduan Pemecahan Masalah (37 halaman), Panduan Informasi Kepatuhan Peraturan dan Keselamatan (9 halaman), Setup Manual (8 halaman), Panduan Pengguna (38 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (37 halaman), Manual (45 halaman), Manual (45 halaman), Lembar Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (5 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (38 halaman), Panduan Memulai (42 halaman), Panduan Referensi (8 halaman), Panduan Memulai (46 halaman)

Place Call

Edit the Call Rate, then Place the Call

Make sure Call is selected (the leftmost icon along the

bottom of the screen) and press OK on the remote

control or press the green Call button on the remote

control.

Once an entry has been located, press OK on the remote

control to invoke the Call menu.

In the More submenu move to Custom call (rightmost) an

press OK.

Use the horizontal Cursor keys on the remote control to

go between Favorites, Recents and Directory and then

down in one of the lists.

Use the down Cursor key on the remote control to move

the cursor down in order to select the More field ( ... ) and

press OK.

Use the horizontal Arrow keys to adjust the call rate and

press the green Call button to place the call.

About Call Rate

Call rate is the term used to express

the amount of bandwidth allocated

to the call and is measured in kbps

(kilobits per second).

The higher the call rate is, the

better the quality will be, but on

the expense of higher bandwidth

consumption.

The system comes with a default

call rate. This is normally set by your

video support team.

Why would you like to temporarily

change this setting? In most cases

you will use it to avoid choking

the video call when you try to call

someone at a higher rate than their

system and connection support.

Call rate cannot be changed during

a call, but you may change it just

before you place a call, as shown

at left.

D1509707 User Guide

Cisco TelePresence TRC 6

Produced: April 2016 for CE 8. 1