Cisco TelePresence SX20 Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Sistem Konferensi Cisco TelePresence SX20. Cisco TelePresence SX20 5 halaman. In-room control on touch 10
Juga untuk Cisco TelePresence SX20: Set Cepat (8 halaman), Panduan Memulai (41 halaman), Panduan Memulai (42 halaman), Panduan Referensi Cepat (2 halaman), Set Cepat (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (29 halaman), Panduan Pemecahan Masalah (37 halaman), Panduan Informasi Kepatuhan Peraturan dan Keselamatan (9 halaman), Setup Manual (8 halaman), Panduan Pengguna (38 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (2 halaman), Panduan Referensi Cepat (2 halaman), Panduan Pengguna (37 halaman), Manual (45 halaman), Manual (45 halaman), Lembar Instalasi (2 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (34 halaman), Panduan Pengguna (38 halaman), Panduan Pengguna (38 halaman), Panduan Memulai (42 halaman), Panduan Referensi (8 halaman), Panduan Memulai (46 halaman)

Halaman Cetak

Cisco TelePresence SX20 Panduan Pengguna

3. Camera Control

While on a call, there may be capability to control the camera on both sides of the call. Camera control

on your side of the call is called

A. Near End Camera Control

i. While on a call or not on a call (as shown here),

move the cursor up to the upper right corner to the

'Camera'

icon. Press

'OK'

iii. You may now adjust the pan, zoom and tilt of the

camera. Use

'Increase'/ 'Decrease'

control to adjust the zoom and the cursor controls to

adjust the pan and tilt. Press

B. Far End Camera Control

i. Navigate to

'Participants'

corner and press

'OK'

list of the participants will then appear.

iii. To control the far end camera, navigate to

'Camera'

and click

'OK'

'Near End'

and on the other side of the call is called

on the remote control.

controls on the remote

'Back'

to exit the menu.

in the upper right

on the remote control. A

on the remote control.

'Far End.'

ii. The

'Camera'

icon will now appear. Press

again on the remote control.

ii. A menu showing a list of the participants on

the call will now appear. Navigate to the

participant whose camera you want to control

and press

'OK'

on the remote control.

A submenu will now appear.

Note:

if you select

'Drop'

be disconnected from the call.

iv. Adjust the pan, tilt and zoom and use

'Back'

on the remote control to exit.

'OK'

that participant will

'OK'

August 2019