Cisco TelePresence System Codec C90 Panduan Memulai - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Sistem Konferensi Cisco TelePresence System Codec C90. Cisco TelePresence System Codec C90 42 halaman. Telepresence system
Juga untuk Cisco TelePresence System Codec C90: Panduan Pengguna (44 halaman), Manual (25 halaman), Panduan Pemecahan Masalah (37 halaman), Panduan Instalasi (2 halaman), Panduan Pengguna (48 halaman), Panduan Memulai (46 halaman)

Halaman Cetak

Cisco TelePresence System Codec C90 Panduan Memulai

Cisco TelePresence Systems

GettinG started Guide

Table of contents

Introduction

Command line interface

Setting the menu password using the command line interface

When starting up the system for the first time the

Administrator Settings menu password is not set.

NoTE: We strongly recommend that you define a password

to protect the Administrator Settings menu, since these

settings affect the behavior of the video conference system.

The Administrator Settings menu password cannot be set

using the Touch controller. If your system does not have a

remote control, you have to set the menu password from

the command line interface.

Back to task overview

User interfaces

Configuration

Signing in to the command line interface

1. To find the IP address of the system, tap

> System Information

on the Touch controller.

The IPv4 Address and/or IPv6 Address is listed in the

NETWORK section.

2. Open a command line interface (SSH or Telnet) using

the system's IP address.

3. Enter your codec/system user name and password when

prompted.

The default user name is

admin

Setting the menu password

1. Connect to the system through the network or the

serial data port, using a command line interface (SSH or

Telnet).

2. Type the following command:

xCommand SystemUnit MenuPassword Set

Password: <password>

The password format is a string with 0–255 characters.

Appendices

More > Settings

with no password set.